Erosion Process Of A Core Clay In Earth And Rockfill Dams : Laboratory Experiments And Numerical Modelling
2021
Autre
Publications Internationales

Université M'hamed Bougara - Boumerdes

K
Kadri, Mohammed
B
Benamar, Ahmed

Résumé: Internal erosion of dam’s embankments is a complex process and considered as the main cause of hydraulic works failure. Laboratory experiments provide a potential insight into the processes involved. Particles detachment from a core of earth and rock fill dams within a crack submitted to water seepage may lead to backward erosion which gradually progresses till forming a pipe. Clay of designed core must provide a quite good resistance against erosion, which depends on material and flow characteristics. The present study reports the results from hole erosion tests (HET) aiming to assess the erodibility of a clayey soil collected from a deposit by Tipaza (Algeria) and used in the core confection of an earthen dam. For this purpose, tests were performed under successive hydraulic loads and the pressure drop was measured as close as possible to the pipe edges. Hydrodynamic parameters effect on erosion rate of tested soil was investigated and the susceptibility of tested soil to erosion was addressed. A numerical simulation of turbulent flow in hole pipe using FEM was carried out to approach the hydrodynamic process occurring inside the hole and to compute shear stress acting along the wall. Numerical values of local shear stress were matched with analytical values and used to describe the area impacted by erosion and the hole radius evolve. Numerical results showed that the usual analytical evaluation of shear stress along the hole overestimates strongly the effect of seepage on the hole wall. Attempts are also made to assess the erodibility classification of tested soil from analytical and numerical results to estimate the deviation usually affecting the interpretation of HET

Mots-clès:

erosion
het
earthen dam
core clay
flow
hydrodynamic
numerical
Nos services universitaires et académiques

Thèses-Algérie vous propose ses divers services d’édition: mise en page, révision, correction, traduction, analyse du plagiat, ainsi que la réalisation des supports graphiques et de présentation (Slideshows).

Obtenez dès à présent et en toute facilité votre devis gratuit et une estimation de la durée de réalisation et bénéficiez d'une qualité de travail irréprochable et d'un temps de livraison imbattable!

Comment ça marche?
Nouveau
Si le fichier est volumineux, l'affichage peut échouer. Vous pouvez obtenir le fichier directement en cliquant sur le bouton "Télécharger".
Logo Université


Documents et articles similaires:


footer.description

Le Moteur de recherche des thèses, mémoires et rapports soutenus en Algérie

Doctorat - Magister - Master - Ingéniorat - Licence - PFE - Articles - Rapports


©2025 Thèses-Algérie - Tous Droits Réservés
Powered by Abysoft
contact@theses-algerie.com