Influence Of Film Thickness And Arn2 Plasma Gas On The Structure And Performance Of Sputtered Vanadium Nitride Coatings
2019
Articles Scientifiques Et Publications
Sciences Et Technologie

Université Abbes Laghrour - Khenchela

G
GHELANI Laala
L
Linda Aissani, Akram Alhussein, Corinne Nouveau, Laala Ghelani, Mourad Zaabat

Résumé: We investigated the effect of film thickness on the structure and properties of V-N coatings deposited by magnetron sputtering in an argon and nitrogen atmosphere. The nitrogen percentage was changed between 10 and 20%. Firstly, structural and morphological properties of VN films were observed, analyzed and subsequently followed by a detailed investigation on the mechanical and tribological properties of these coatings. It has been shown that film structure, hardness and wear resistance significantly changed with varying the film thickness and the nitrogen percentage. In the case of films deposited under 10%N2, the presence of V2N phase was evident. With increasing nitrogen ratio in the deposition chamber from 10 to 20%, the structure was changed from (hc)V2N to multi phases of V2N and (fcc) V-N (formation of different vanadium nitrides). The thick films containing more nitrogen were slightly dense compared to the thinner ones presenting rough surface and columnar morphology. Nanoindentation measurements showed that film mechanical behavior depends on its thickness, nitrogen percentage and microstructural features. The film hardness first increased with its thickness and then decreased. The highest hardness of 26.2 GPa was obtained for the film deposited under 20%N2, which is correlated with its dense structure and film stoichiometry. The film thickness has a significant effect on the tribological properties of V-N films. The minimum friction coefficient of 0.4 was found for the thickest film of 2500 nm. The wear rate gradually decreased with increasing the film thickness, due to the high hardness, presence of VN phase and the strong adhesion between film and substrate.

Mots-clès:

Nos services universitaires et académiques

Thèses-Algérie vous propose ses divers services d’édition: mise en page, révision, correction, traduction, analyse du plagiat, ainsi que la réalisation des supports graphiques et de présentation (Slideshows).

Obtenez dès à présent et en toute facilité votre devis gratuit et une estimation de la durée de réalisation et bénéficiez d'une qualité de travail irréprochable et d'un temps de livraison imbattable!

Comment ça marche?
Nouveau
Si le fichier est volumineux, l'affichage peut échouer. Vous pouvez obtenir le fichier directement en cliquant sur le bouton "Télécharger".
Logo Université


Documents et articles similaires:


footer.description

Le Moteur de recherche des thèses, mémoires et rapports soutenus en Algérie

Doctorat - Magister - Master - Ingéniorat - Licence - PFE - Articles - Rapports


©2025 Thèses-Algérie - Tous Droits Réservés
Powered by Abysoft