Enhancing The Biomethane Production From Tannery ‎wastewater By Thermal Pretreatment
2017
Articles Scientifiques Et Publications
ASJP
Autre

Université M'hamed Bougara - Boumerdes

A
Achouri, O
P
Panico, A
B
Bencheikh-lehocine, M
D
Derbal, K
P
Pirozzi, F

Résumé: Anaerobic Digestion (AD) is often chosen as a suitable treatment ‎for tannery wastewater (TWW) since this waste stream is rich in ‎organic matter. Nevertheless, the high organic load and the ‎presence of compounds commonly used in the leather production ‎process and responsible for inhibiting the biological activity (e.g. ‎chromium and sulphide) limit the full capitalization of the whole ‎potential in producing biomethane from this low-cost and ‎interesting source of renewable energy. Pretreatment of ‎substrates is considered by most as the solution to overcome this ‎negative aspect as a higher biomethane production in a shorter ‎time is expected after that. Actually in this study three different ‎temperatures have been tested, in detail, 90, 80, and 70 °C, to ‎pretreat a real TWW prior to a mesophilic AD process conducted ‎in a series of batch biomethane potential (BMP) tests aimed at ‎evaluating the optimum temperature that can result in increasing ‎the soluble COD content and consequently the AD performance . ‎After the pretreatment, the soluble COD concentration increased ‎from a minimum of 11% to a maximum of 80%: which resulted in ‎an increase of the biomethane production compared with the raw ‎substrate. The highest temperature (90°C) investigated gave the ‎highest increasing in soluble COD but had a negative effect on ‎AD process performance, as the final production of biomethane ‎was 178 ml CH4/g TVS, more than 4 folds less than the maximum ‎yield of 891 ml CH4/g TVS obtained from the sample pre-treated ‎at 80°C where the increase in soluble COD was by 57%. These ‎results highlight the critical aspect of the thermal pretreatment: ‎the increase of temperature can enhance the biomethane ‎production as well as reduce it, therefore the choice of the most ‎suitable temperature depends strongly on the characteristics of ‎the substrate and it can be made only through experimental tests. ‎

Mots-clès:

Thermal pretreatment
‎Biomethane
Tannery wastewater
‎Anaerobic digestion‎

Publié dans la revue: algerian journal of environmental science and technology

Nos services universitaires et académiques

Thèses-Algérie vous propose ses divers services d’édition: mise en page, révision, correction, traduction, analyse du plagiat, ainsi que la réalisation des supports graphiques et de présentation (Slideshows).

Obtenez dès à présent et en toute facilité votre devis gratuit et une estimation de la durée de réalisation et bénéficiez d'une qualité de travail irréprochable et d'un temps de livraison imbattable!

Comment ça marche?
Nouveau
Si le fichier est volumineux, l'affichage peut échouer. Vous pouvez obtenir le fichier directement en cliquant sur le bouton "Télécharger".


footer.description

Le Moteur de recherche des thèses, mémoires et rapports soutenus en Algérie

Doctorat - Magister - Master - Ingéniorat - Licence - PFE - Articles - Rapports


©2025 Thèses-Algérie - Tous Droits Réservés
Powered by Abysoft